CAB Apollo 1 Operator's Manual download pdf (Page 9)

cab Produkttechnik GmbH & Co KG 9

[TABLE OF CONTENTS]

[COMMAND LIST][INDEX]

Hermes

Apollo

A-series

This

function is

available

for:

[ESC][i][L][S]

PRODUCT MARKING AND BARCODE IDENTIFICATION

Introduction

IMPORTANT : We highly recommend to read the introduction first !!

• The described commands and sequences are tested and approved with original cab printers.

cab Produkttechnik cannot guarantee that all functions are available on OEM products.

• All sample labels are created with a 300 dpi A-series printer,

• All measurements are in millimeters for the usage in international markets- Label positions have to

be recalculated if the printer is set to "country = USA".

• Some described functions are only available if your printer contains the actual firmware. We

recommend to download and install the most actual firmware release from our website at:

http://www.ca/jointfilesconvert/359582/bgmbh.com

• We tried our best to write an easy understandable programmer´s manual which should contain every

possible function of cab printers.

A lot of different methods have been used to make sure that every shown example works properly

and a few proof reads have been done to avoid any error in this manual.

Nevertheless - we would appreciate your comments , where more explanation is required and where

we have to do things better. Every comment is welcome and will influence our future work.

Thank you for your help !

Nomenclature, Syntax of the commands

• All commands are accepted when the line end identifier is transmitted, with the exception of ESC

commands, they are processed as soon as the required character is received.

• Carriage returns are not displayed in the headlines and not in the example files of this manual, to

keep a better overview. Carriage Returns (ASCII 13, HEX 0D) are only shown in the syntax

description in italic letters ( CR ).

You may use either CR (carriage return), LF (line feed) or CR/LF (carriage return/ line feed)

(See the ASCII table in the APPENDIX of this manual)

• It is not required to use special charcters to create a label format. Data can be keyed in with a

simple text editor.

• For a better overview it is allowed to add spaces or tabs within a command line. Numeric

parameters accept additional zeroes.

• Separators for the parameters are either semicolons or commas.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 254 255

No comments

CAB Apollo 1 Operator's Manual Page 9