CAB Apollo 1 Operator's Manual download pdf (Page 48)

48 cab - Produkttechnik GmbH & Co KG / Tharo Systems, Inc.

System Mode SETUP

To enter the SETUP mode, use either one of the procedures described below :

either : press both keys, the key and the key

simultaneously when switching on the printer, and keep them

pressed down, until the system test is completed;

or : in ONLINE mode, press both keys, the key and the

key simultaneously for at least 5 seconds.

In SETUP mode, various printer parameters can be specified to suit the current

print requirements. (for details see Chapter 9)

Display

Following the completion of the system test, the display briefly shows "SET-

UP", followed by "Land" or "Country". Depending on the selection, all of the

setup parameters and their settings will be shown.

LED Display

All LEDs off.

Function Keys

ONL key Stores the chosen settings of the setup parameters and

completes the SETUP mode.

(i.e. switch into ONLINE mode/ LED ONL on)

FF key Skips to next setup parameter.

Reduces numerical setup values.

CAN key Skips to previous setup parameter.

Increases numerical setup values.

PSE key Confirms selected settings for parameters.

Table 8 g Function keys in SETUP mode

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 138 139

No comments

CAB Apollo 1 Operator's Manual Page 48