CAB Apollo 1 User Manual download pdf (Page 25)

cab - Produkttechnik GmbHENG-24

Montage des Spendesensors

43 5 6

Present Sensor

The optional present sensor in connection with printers with internal rewinder

allows for on-demand label dispensing. That means, the labels are removed from

the silicon liner immediately after printing, and then available in a dis-pense

position ready for further processing.

The present sensor (2) consists of two components, the dispense edge (18) and

the present sensor photocell (6). The presence of a label (19) in dispense position

is observed by the photocell. Through its connection to the peripheral port of the

Apollo, the signal pauses the print of the next label until the label in the dispense

position is removed.

Note : When editing or creating labels in demand mode, make sure that the part of

the label which lies directly underneath the photocell is only colored (black) to a

maximum of 50%. Higher blackening/ density print may cause malfunctions of the

sensor.

The Apollo is generally shipped with the tear-off plate (1) mounted. When

operating in dispense mode, the tear-off plate has to be replaced with the present

sensor (2) :

1. Turn lever (4) counter-clockwise until it stops.

2. Remove the tear-off plate (1) from the mounting holes (3).

3. Slide the present sensor (2) into the mounting holes (3).

4. Turn lever (4) clockwise until it stops.

5. Connect the cable (5) of the present sensor (6) to the 15 pin peripheral port of

the Apollo.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32 33

No comments

CAB Apollo 1 User Manual Page 25