CAB Apollo 1 User Manual download pdf (Page 6)

ENG-5cab - Produkttechnik GmbH

Loading Labels

1 2 3 4 5

6789 1011

1. Open the cover.

2. Lift the printhead by rotating the lever (1) clockwise until it stops.

3. Loosen the media retainer knurled screw (5), swing the media retainer (4)

backwards and place the label roll (2) onto the media hub (3).

4. Swing the media retainer (4) against to the media hub (3) and push it inwards

until it rests against the side of the label roll. Tighten the knurled screw (5).

5. Slide the media guide (8) into its outermost position.

6. Unroll a length of label stock from the media roll and feed it through as shown

in figure.

The solid line represents the feed path of outside-rolled labels, the broken line

of inside-rolled labels. The broken-dotted line shows the media path of fanfold

paper (6).

It is particularly important to ensure that the media strip slides properly

between the fittings of the adjustable label edge sensor (9).

7. Slide the media strip right through the space between the print roller and the

printhead until it comes out of the Apollo.

8. Slide the media guide (8) back towards the edge of the media strip.

9. Turn the lever (1) counter-clockwise until it stops and, thereby, lock the

printhead.

10. Close the cover.

1 2 3 4 5 6 7 8 9 10 11 ... 32 33

No comments

CAB Apollo 1 User Manual Page 6